Kohler K-9498-BV Installationsanleitung

Stöbern Sie online oder laden Sie Installationsanleitung nach Zugangskontrollleser Kohler K-9498-BV herunter. KOHLER K-9498-BV Installation Guide Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 2
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
1021754-9-A
SERVICE KIT INSTRUCTIONS
Rotating Trim Ring
Replacement
K-9498
Rotating
Ring
Keypad
Harness
Connection
Detent
O-Ring
Housing
Nut
Spring
Tool
Locate
Notch
Remove
Ring
Install
Ring
Remove Old Rotating Ring
- Turn power to the whirlpool off.
- Inspect new ring for damage before you begin installation.
- Slip the tool between the whirlpool and the rotating ring in the removal
position. Align the notch in the tool with the tab on the keypad. W ith
the notch engaged with the tab, rotate the tool approximately 30_
counterclockwise.
- Carefully pull the rotating ring and keypad out of the housing.
IMPORTANT! Make sure the harness cable does not fall back
through the housing.
- Pull a minimum of 12” (30.5cm) of cable through the housing.
Disconnect the harness connection from the keypad.
- Useyourthumbstopressthekeypadoutoftherotatingring.
Seitenansicht 0
1 2

Inhaltsverzeichnis

Seite 1 - Remove Old Rotating Ring

1021754-9-ASERVICE KIT INSTRUCTIONSRotating Trim RingReplacementK-9498RotatingRingKeypadHarnessConnectionDetentO-RingHousingNutSpringToolLocateNotchRe

Seite 2 - Verify Function

1021754-9-A2Kohler Co.Install New Rotating Ring- Place the keypad on a flat surface with the decal side down. Align thetabs with the new rotating ring

Kommentare zu diesen Handbüchern

Keine Kommentare