Kohler K-4886-0 Installationsanleitung PDF herunterladen (Seite 3)

2. Install the Bidet

NOTE: K-4896 bidet is shown throughout the instructions.

Install the bidet faucet and drain according to the manufacturer’s

instructions.

Set the bidet on the ﬂoor in its mounting location.

Trace the outline of the bidet base, and mark the location of the two

side mounting holes.

Remove the bidet from the mounting location.

Drill two 3/16″ holes at the marked side mounting hole locations.

Thread the ﬂoor bolts (included) into the mounting holes.

Apply a bead of sealant around the base of the bidet, and carefully

align the bidet inside the outline drawn on the ﬂoor.

Position the bidet in the mounting location so both of the ﬂoor bolts

extend through the bidet side mounting holes.

CAUTION: Risk of personal injury or product damage.

Vitreous china can break or chip easily if the nuts are

overtightened or the product is handled carelessly.

Assemble the bolt cap bases, washers, and nuts. Hand-tighten the

nuts, then tighten an additional 1/2-turn with a wrench.

If the ﬂoor bolts extend more than 1/4″ (6mm) from over the top of

the nut, loosen the nut and thread the bolt further into the ﬂoor.

Retighten the nuts, and install the bolt caps.

Kohler Co. 3 1020412-2-B

1 2 3 4 5 6 7 8 ... 15 16

Keine Kommentare

Kohler K-4886-0 Installationsanleitung Seite 3