Kohler K-1394-H2-96 Installationsanleitung PDF herunterladen (Seite 16)

Troubleshooting (cont.)

Symptoms Probable Causes Recommended Action

1. User keypad does not

illuminate when power

button is pressed or outer

ring is rotated.

A. No power to control. A. Check wiring and connect power.

B. GFCI tripped. B. Reset GFCI.

C. Wiring harness from user

keypad to control is loose,

disconnected or damaged.

C. Check wiring for proper

connections. Replace wiring

harness if necessary.

D. User keypad does not work. D. Replace user keypad.

E. Control does not work. E. Replace control.

2. Motor starts, but all jets

are not functioning.

A. Jet is closed. A. Rotate jet trim counterclockwise to

open.

B. Jet not installed correctly. B. Reinstall jet; check for O-ring

damage.

C. Jets are blocked. C. Remove blockage.

3. User keypad is

illuminated, but does not

respond to buttons or

outer ring.

A. Control program is locked. A. Reset GFCI.

B. Wiring harness from user

keypad to control is loose,

disconnected or damaged.

B. Check wiring for proper

connections. Replace wiring

harness if necessary.

C. User keypad does not work. C. Replace user keypad.

D. Control does not work. D. Replace control.

4. User keypad indicator bar

keeps scanning at

power-up.

A. Control program is locked. A. Reset GFCI.

B. Wiring harness from user

keypad to control is loose,

disconnected or damaged.

B. Check wiring for proper

connections. Replace wiring

harness if necessary.

C. User keypad does not work. C. Replace user keypad.

D. Control does not work. D. Replace control.

5. User keypad is

illuminated, but pump

won’t start.

A. Power cord from pump to

control is loose, disconnected or

damaged.

A. Check wiring for proper

connections.

B. Pump does not work. B. Replace pump.

C. Control does not work. C.

Replace control.

6. Motor runs but pump

won’t prime (cavitates).

A. Pump is shimmed too high. A. Lower pump/control to subﬂoor

level.

B. Small air leak at pump inlet. B. Securely tighten nut(s) on intake

side of pump.

C. Motor/pump does not work. C. Replace motor/pump.

D. Control does not work. D. Replace control.

7. Little or poor water ﬂow

from dual ﬁll ports.

A. Water supply lines blocked. A. Remove blockage.

B. Transfer valve not fully open. B. Rotate transfer valve handle.

8. Little or poor water ﬂow

from Waterfall.

A. Suction or harness blocked. A. Remove blockage.

B. Pump does not work. B. Replace pump.

C. Control does not work. C. Replace control.

9. Riverjets run, but

Whitewater/Rapids jets

do not operate as

described.

A. Insufficient water in whirlpool

basin.

A. Fill whirlpool so water covers

water-level sensors.

1022205-2-D 16 Kohler Co.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 55 56

Kommentare zu diesen Handbüchern

Keine Kommentare

Kohler K-1394-H2-96 Installationsanleitung Seite 16

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Oberirdisches Schwimmbadzubehör Kohler K-1394-H2-96