Kohler Power Systems 14/20RESA Bedienungsanleitung PDF herunterladen (Seite 18)

TP-6804 12/1118 Section 1 Descriptions and Service Views

1.7 Accessories

The following optional accessories are offered for the

RESA and RESAL generator sets.

1.7.1 Carburetor Heater

An optional carburetor heater is recommended for

improved cold starting in locations where the ambient

temperature drops below 0_C (32 _F). The carburetor

heater prevents condensation and carburetor icing. The

heater requires a continuous source of 120 VAC power.

See the generator set Installation manual for more

information.

1.7.2 Fuel Regulat or Heater (20RESA

and RESAL only)

An optional fuel regulator heater for the

20RESA/20RESAL is recommended for improved cold

starting in locations where the ambient temperature

drops below --18_C(0_F). The heater requires a

continuous source of 120 VAC power.

See the generator set Installation manual for more

information.

1.7.3 OnCue Home Generat or

Management System

The Kohlerr OnCuet Home Generator Management

System allows monitoring and control of your RESA or

RESAL generator set from a personal computer located

in your home or at other remote locations. OnCuet can

also be configured to send email or text message

notifications in the event of a generator set fault.

Note: Be sure to obtain the correct version of the

OnCuet kit for the RDC2/DC2 controller.

OnCuet version 3.0 is required for RESA/RESAL

generator sets equipped with the RDC2/DC2 controller.

OnCuet versions numbered 1.x are not compatible

with the RDC2/DC2 controller.

1.7.4 Programmable Int erface Module

(PIM)

The optional Programmable Interface Module (PIM)

provides two programmable inputs and six

programmable dry contact outputs for connection to

customer-supplied equipment. The outputs are

controlled by the RDC2 controller, and can also be

controlled remotely using the OnCue program.

The PIM is mounted in a NEMA 3R aluminum enclosure,

which can be mounted indoors or outdoors. See the

installation instructions provided with the PIM.

1.7.5 Load Control Module (LCM)

The optional Load Control Module (LCM) provides an

automatic load management system to comply with

Section 702.5 of NEC 2008. The installer is responsible

for ensuring that the power system installation complies

with all applicable state and local codes.

The LCM automatically manages up to six residential

loads. Four power relays are provided for management

of non-essential secondary loads, and two relays are

available to control two independent air conditioner

loads.

The LCM is controlled by the RDC2/DC2 controller. The

load on the generator set is monitored, and loads are

added or shed in the order of their priority. See

specification sheet G6-120 and the LCM installation

instructions for more information.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 71 72

Kommentare zu diesen Handbüchern

Keine Kommentare

Kohler Power Systems 14/20RESA Bedienungsanleitung Seite 18

Kommentare zu diesen Handbüchern