Kohler K-1713 Installationsanleitung PDF herunterladen (Seite 9)

6. Install the Water Supply and Steam Line

WARNING: Risk of scalding. Do not plumb a trap, shut-off valve, or pressure relief valve into the

steam line. Plumbing the pressure relief valve into the steam line can be hazardous, if the steam

outlet is capped.

Install the Water Supply Line to the Generator

NOTE: For all NPT threaded connections, use pipe tape or pipe sealant. Do not overtighten the ﬁttings.

Connect to an existing cold water line, and run a 3/8″ cold water line to a shut-off valve before the

in-line water ﬁlter.

Before ﬁnal connection to the steam generator, ﬂush out the water supply line into a large pail. This

removes any debris, silt, sand, or other material that may be in the line.

Install 3/8″ copper tubing with a union ﬁtting between the in-line water ﬁlter and the water inlet to

the steam generator.

Connect the water supply line to the steam generator.

Fill the steam generator with water and check for leaks.

NOTICE: Steam generators are equipped with an automatic shut-off. The water will stop after the unit is

full. If the water ﬂows out of the steam outlet shut off the water and consult the ″Troubleshooting Guide″

or contact the Customer Care Center using the number located on the back of this document.

If the water supply line exceeds 10’ (3 m) or is exposed to cold areas, insulate the piping with

appropriate insulation.

Install the Steam Line

Steam Head

Drain Pan

Steam Trap

Do not run pipes

down and then up.

Pitch toward generator.

Water Inlet

Wall Stud

Provide clearance

from wall.

6" (15.2 cm)

from Floor

1" (2.5 cm) Min

2-1/2" (6.4 cm)

Shut-Off

Valve

Copper

Union

Recommended

In-Line Water Filter

Tee

Temporary

Nipple

Kohler Co. 9 1053772-2-E

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare

Kohler K-1713 Installationsanleitung Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Stromgeneratoren Kohler K-1713