Kohler K-1160-HD-0 Installationsanleitung PDF herunterladen (Seite 15)

Troubleshooting Procedures (cont.)

Symptoms Probable Causes Recommended Action

1. Whirlpool does not start

or stop.

A. No power to motor. A. Check that the pump and heater

are plugged in and that the GFCI

or RCD is switched to the correct

position. Plug in or reset the

GFCI/RCD as needed.

B. Air hose is loose or disconnected. B. Check that the hose is connected

at both the receiver/pump end

and to the air switch. Reconnect

if needed.

C. Air hose is pinched or kinked. C. Adjust hose to clear the

pinched/kinked area. If the

tubing is pinched/kinked and

cannot be readjusted, or no

noticeable pinch/kink is

apparent, poke a small hole in

the tubing with a tack and try

the system again.

D. Push button assembly is damaged. D. Replace the push button

assembly.

E. Push button has grease in the

bleed area.

E. Disassemble the push button

assembly and wipe away any

excess grease. Reassemble the

button and retry the system.

F. Air hose is damaged. F. Replace the air hose.

G. Motor/pump does not work. G. Replace the motor/pump.

2. Motor starts, not all jets

are functioning.

A. Jet is closed. A. Rotate jet trim ring

counterclockwise to open.

B. Jet not installed correctly. B. Reinstall jet; check for O-ring

damage.

C. Jets are blocked. C. Remove blockage.

3. Pump does not prime. A. Pump shimmed too high. A. Lower pump support bracket.

4. Noisy operation. A. Pump banding straps have not

been cut. (Models with support

blocks only.)

A. Cut pump banding straps with

tin snips.

B. Jet O-ring dislodged. B. Remove jet, replace and lubricate

O-ring, and reinstall jet.

5. Heater does not operate.

(“H” models only)

A. No power to heater. A. Reset the GFCI or RCD.

B. Water temperature exceeds 104°F

(40°C).

B. Allow water to cool and heater

will reengage.

C. Heater does not work. C. Replace heater.

Kohler Co. 15 1193347-2-A

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare

Kohler K-1160-HD-0 Installationsanleitung Seite 15

Kommentare zu diesen Handbüchern