Kohler K-3753-96 Installationsanleitung PDF herunterladen (Seite 15)

Garantía (cont.)

limitación de daños particulares, incidentales o indirectos, por lo que estas

limitaciones y exclusiones pueden no aplicar a su caso. Esta garantía le otorga ciertos

derechos legales especíﬁcos. Además, usted puede tener otros derechos que varían de

estado a estado y provincia a provincia.

El presente documento constituye la garantía exclusiva por escrito de Kohler Co.

Troubleshooting Guide

Symptoms Recommended Action

1. Poor ﬂush. A. Adjust the tank water level to match the waterline.

B. Fully open the water supply shut-off valve.

C. Clear obstructions from the trapway, jet or bowl rim holes.

D. Clear obstructions in the soil pipe or vent pipe.

2. No ﬂush. A. Make sure the push button rods are in place. Adjust as

needed, following the directions in the Installation and Care

Guide.

3. The ﬁll valve

turns on/off by

itself or it runs,

allowing water

to enter the

tank.

A. Adjust push button rods for proper slack so the ﬂush valve

seal isn’t held off the ﬂush valve.

B. Clean or replace the ﬂush valve seal if it is worn, dirty, or

misaligned with the valve seat or ﬂush valve seat is damaged.

C. Remove the tank and tighten the ﬂush valve nut if ﬂush valve

gasket is leaking. Do not overtighten. If leakage continues

replace the gasket.

D. Clean the ﬁll valve seat/seat washer of debris or replace the

piston/seat washer assembly.

E. Replace the ﬁll valve if the valve ﬂoat sinks.

F. Adjust the tank water level if it is too high.

4. Long tank ﬁll

cycle.

A. Fully open the water supply shut-off valve.

B. Clean the valve inlet, valve head, or supply line. Flush the

lines.

5. Noisy tank ﬁll

cycle.

A. Partially close the water supply shut-off valve if the water

pressure to the toilet is too high. Check the toilet performance

following any such adjustment.

B. Remove dirt or obstructions from the valve head. Flush the

lines.

Guide de dépannage

Symptômes Action recommandée

1. Chasse faible. A. Régler le niveau d’eau du réservoir au niveau du repère.

B. Ouvrir complètement la valve d’arrêt d’alimentation.

C. Dégager toutes obstructions du siphon, jet ou trous du rebord

de la cuvette.

D. Dégager le tuyau d’évacuation ou d’aération.

2. Pas de chasse. A. S’assurer que les tiges de bouton-poussoir soient bien en place.

Ajuster si nécessaire, en suivant les instructions du guide

d’installation et d’entretien.

Kohler Co. 15 1145593-2-C

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Kohler K-3753-96 Installationsanleitung Seite 15

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Kohler K-3753-96