Kohler K-1122-W1-47 Installationsanleitung PDF herunterladen (Seite 7)

3. Make the Electrical Connections – USA and Mexico

WARNING: Risk of electric shock. Make sure the power has been disconnected before performing

the following procedures.

WARNING: Risk of electric shock. Connect the junction box and whirlpool pump to a properly

grounded, grounding-type duplex receptacle protected by a Ground-Fault Circuit-Interrupter (GFCI)

or Residual Current Device (RCD). Do not remove the grounding pins from the plugs. Do not use

grounding adapters.

NOTE: A label identifying the model number and electrical rating of the whirlpool is located near the

whirlpool pump.

NOTICE: The whirlpool pump and junction box are equipped with two cords and plugs. A qualiﬁed

electrician must install a dedicated GFCI- or RCD-protected, 120 V, 15 A, grounded duplex outlet. No

other load should be on this circuit.

Install a duplex electrical outlet behind the bath, and within reach of the 24″ (610 mm) power cord.

Plug the whirlpool pump and junction box into this outlet.

NOTE: Make sure the air actuator tubing is securely attached to the pump, and is not kinked or

damaged.

Bond in accordance

with applicable codes.

Junction Box

Power

Supply

24" (610 mm)

Maximum Distance

24" (610 mm)

Maximum Distance

Install a GFCI-protected

120 V, 15 A grounded outlet.

Kohler Co. 7 1204118-2-B

1 2 3 4 5 6 7 8 9 10 11 12 ... 55 56

Keine Kommentare

Kohler K-1122-W1-47 Installationsanleitung Seite 7