Kohler K-702404-L-SH Installationsanleitung PDF herunterladen (Seite 5)

3. Locate the Wall Jambs

Position the wall jamb with the base centered on the shower threshold.

Make a pencil mark at the bottom pre-drilled hole.

Remove the wall jamb.

NOTE: Some ﬁling may be required on the wall jambs if your bath unit has curved corners.

NOTE: When installing on ceramic tile, use a center punch to nick the surface of the glaze. Tap the center

punch lightly with a hammer to avoid cracking the tile.

Slowly drill a pilot hole at the mark with a 3/16″ drill bit.

Insert a wall anchor into the hole.

Secure the wall jamb loosely in place using a #8-18 x 2″ panhead screw.

Level the wall jamb.

Make a pencil mark at each of the three remaining pre-drilled holes.

Move the wall jamb out of the way.

Slowly drill a pilot hole at each of the three remaining marks with a 3/16″ drill bit.

Thoroughly clean the shower ledge.

Insert a wall anchor into each drilled hole.

Secure the wall jamb in place using three #8-18 x 2″ panhead screws.

Repeat for the other wall jamb, making sure it is directly opposite the installed wall jamb.

Wall Jamb

Drill holes.

Anchor

#8-18 x 2"

Screw

Kohler Co. 5 1036565-2-B

1 2 3 4 5 6 7 8 9 10 ... 43 44

Keine Kommentare

Kohler K-702404-L-SH Installationsanleitung Seite 5