Kohler K-1160-HD-0 Installationsanleitung PDF herunterladen (Seite 9)

5. Make the Electrical Connections

WARNING: Risk of electric shock. Make sure the power has been disconnected before performing

the following procedures.

WARNING: Risk of electric shock. Connect the pump and heater (if included) to properly

grounded, grounding-type receptacles protected by Ground-Fault Circuit-Interrupters (GFCI’s) or

Residual Current Devices (RCD’s). Do not remove the grounding pins from the plugs. Do not use

grounding adapters.

NOTE: A label identifying the model number and electrical rating of the whirlpool is located near the

whirlpool pump.

NOTICE: The pump and heater (if included) are each equipped with a cord and plug. All wiring for the

heater has been completed at the factory. A qualiﬁed electrician must install a GFCI- or RCD-protected, 120

V, 15 A, grounded outlet for the pump, and another for the heater. No other load should be on these

circuits.

Install an electrical outlet behind the whirlpool, and within reach of the 24″ (610 mm) pump power

cord.

Plug the pump plug into this outlet.

NOTE: Make sure the air actuator tubing is securely attached to the pump, and is not kinked or

damaged.

For units with heaters, install a second outlet behind the whirlpool and within reach of the 24″ (610

mm) heater power cord.

Plug the heater plug into this outlet.

Install a second

GFCI-protected outlet for "H"

models for the in-line heater.

24" (610 mm) Max. Distance

Between Pump and Outlet

24" (610 mm) Power Cord

Bond in accordance

with applicable codes.

Heater

Install a GFCI-protected

120 V, 15 A grounded outlet.

Kohler Co. 9 1193347-2-A

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 47 48

Keine Kommentare

Kohler K-1160-HD-0 Installationsanleitung Seite 9