Kohler K-705729-L-SHP Installationsanleitung PDF herunterladen (Seite 8)

3. Locate the Bottom Track

NOTE: When installing a 60″ (152.4 cm) door, the hinge side lite is the narrow piece of glass with 4 holes

in it.

Cut length of the supplied VHB foam tape to match the width of the hinge side lite (if necessary).

Remove the backing from the tape and, starting adjacent with the end of the track on the hinge side,

apply the tape to the ﬂat top of the bottom track. Position the tape about 3/8″ (1 cm) from the

groove in the bottom track, centered on the ﬂat portion of the bottom track.

NOTE: Position the bottom track far enough toward the outside (dry side) of the shower threshold to

allow the strike jamb or strike lite ﬁller to sit behind the bottom track. The back edge of the bottom track

should be at least 1″ (2.5 cm) from the inside edge of the shower threshold to allow the rest of the door to

sit on the threshold.

Position the bottom track on the threshold with the slanted section toward the inside (wet side) of

the shower.

Make sure the front edge of the bottom track is an equal distance from the front edge of the shower

ledge at all points.

Temporarily secure the bottom track to the ledge with masking tape (do not apply the tape over the

VHB foam tape).

Mark the location of the bottom track with a soft pencil.

Position the side lite ﬁller over the VHB foam tape and install it into the groove in the bottom

track.

3/8"

(1 cm)

Bottom Track

VHB Foam Tape

Side Lite Filler

1" (2.5 cm) Min

VHB Foam Tape

Groove

Slanted

Section

Inside of

Shower

1064866-2-C 8 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 59 60

Keine Kommentare

Kohler K-705729-L-SHP Installationsanleitung Seite 8